MkNY83
6/4/2006 5:13:16 PM
Im going to be doing an install on my friends 2000 2-door blazer. HU, speakers, amp and sub. I just did a quick lookover and it doesnt look like anything will be too complicated. The only thing i was curious about is the front speakers...anybody have any problems or advice on taking the panels off???
LORCLAS
6/4/2006 7:40:41 PM
Just make sure you don't forget the two screws that are located under the armrest. Kinda tricky to see. After that it's all just press-ins.
Canadian88
6/4/2006 9:21:22 PM
7mm ratchet with an extension will do the job. I had to mount mine upside down because the wire they left wasn't long enough
MkNY83
6/8/2006 9:35:46 AM
Thanks for the replies...one more question. Are there any easy accessible holes that I can run the power wire through the firewall or will I need to drill. I'm only using 4gauge so its not too big.
djbass_mekanik
6/9/2006 3:20:40 AM
did u run ur power cable already?? and are u doin rear speakers?? those are time consumin, have to KINDA take off the rear panels..
MkNY83
6/9/2006 4:46:29 PM
I havent done anything yet. Im going to get started tomorrow and get as much done as i can. Im also doing the rear speakers, wat do u mean KINDA?? hafta take off the panels? Is this tougher than any regular door panel removal??
Sorry if i dont seem like im following you, but its my friends car so i dont have the chance to just check the car and see wat ur talkin about. Im not going to see him again until I do it...so i dunno wat the panels look like.
djbass_mekanik
6/10/2006 5:57:08 AM
well its not hard but it sill take u sometime, specially if u not used to pullin panels off... on the 2 dr, the whole top half of the panel has to kome off.. not hard, jus have the rite tools... an good luk
