broken into - Page 2

well I have narrowed down my chioces to either this (hillbillyinohio, this one has dual polarity) or this one (not too sure bout the polarity on that one)

The Scytek has negative door locks, so you will need relays.  But either will work.  

well Im pretty sure I will be buying the auto page. any hints on instalation? and how involved is this? Im thinking cutting/splicing wires, but what else? How much of the dash (and anything else?) needs to be taken apart? thanks

Anyone? ^^

For a basic alarm with Keyless you are going to have to splice into 12+, IGN, GND, Door Lock wire, Door trigger Wire, Hood pin(optional), Run a siren, mount your shock sensor, and a few other things...
 
You will have to take apart the dash bezel, the dash underbelly(two pieces), and kick panel all on the drivers side. There is a steel column shroud under the dash belly that you will have to unbolt as well...

hmm what about the remote start? how difficult? I finally have a good solder gun instead of the old crapy one i had, so that should help out. Im hoping to get it installed in a day or so

Oh, I didnt realize you purchased a remote start alarm. Remote starts can be very difficult if you havent done one before. You will need a Bypass module yo bypass the factory security system so the vehicle can start without a key in the ignition. The one you need should be a 555LW from DEI...As far as wiring goes it can be very frustrating and time consuming. If you have never done a remote start before leave yourself about a 5 hour window and a 12 pack of corona to vent when you are finally done...I wouldnt reccomend installing a remote start if you havent done one before, but if you do decide to attempt it just get a wiring sheet from Hillbilly or someone and try to figure it out...

Its not too bad. I taught Xblazer how to do a remote start over AIM.  Let me know.  I can give ya my phone number or aim and we can knock it out.  

that would be great! and some wiring diagrams? I haven't ordered the alarm yet but will soon and hope to start the install next week while im on break. Oh and on a good part, insurance may just cover my head unit! excited about that

shoot me a pm with your truck details and and the alarm you are going to get.  Then we will work from that.