You are currently viewing our forum as a guest, which gives you limited access to view most discussions and access our other features. By joining our community, at no cost, you will have access to start new topics, reply to conversations, privately message other members (PM), respond to polls, upload content and access many other special features. Registration is free, fast and simple, join Blazer Forum today!
I hear the super 44 is awesome. Gives a better sound. The cherry bomb is it's cheaper cousin though . I couldn't afford the super 44, so i went with the CB
__________________
aka "The Picture Vulture"
2001 Blazer LS 2dr 4x4 - Auto - 4.3L V6 - 183,000KM
De-badged | Blue interior lighting | 3" chrome CAI | Cherry Bomb Turbo exhaust
Tinted corners and tails | Black stock rims | Black grille, bow tie, tow hooks | Undercoated frame, wheel wells
Here is how I installed my power inverter. It works great I have played PlayStation in my truck with it! It cost about 40 bucks at Walmart.
1) Remove the lower part of the dash on the drivers side. (Above the Gas and Brake peddles
2) Inside the engine compartment (above where the brake peddle would be on the inside) Look for three indents, that form a triangle. This is where the hole should go (inside the triangle)
In the engine compartment
Inside the truck, you can see one of the small dents of the triangle
3) Drill the hole large enough for your wires
4) Run your wires and don't forget a fuse I used a add-a-fuse deal.
5) Hook to battery, I chose these clips because it is simple and I can unhook it and not fear a drained battery.
6) Now for the wires inside the truck, I ran the under the plastic in the door jams right under my drivers seat
7) I ran a master switch in my center console.
8) Make sure all soldered connections are good and taped well, then hook it up and try it!
Oh ya about the Tint, I Said screw it, it's too hard to do and the temps are now too cold do it, It would freeze to the window over night lol
Okay i got around to cutting the pipe and fitting the tip, Cutting the pipe and putting the tip on made it a little bit louder here is a youtube vid of it