TORQUE specs on steering bAR Balljoints on AN 89 BLazer

	Blazer Forum Classifieds Photo Gallery Search Contact BF Sponsors
Blazer News Member List Forum FAQ Timeslips Recalls TSBs Calendars Register Login

TORQUE specs on steering bAR Balljoints on AN 89 BLazer

Printable Version

Blazer Forums >> Mechanical & Maintenance >> Steering, Suspension & Drivetrain >> TORQUE specs on steering bAR Balljoints on AN 89 BLazer

Page: [1]

Message

<< Older Topic Newer Topic >>

TORQUE specs on steering bAR Balljoints on AN 89 BLazer - 10/12/2007 2:46:02 PM

Goatmanof70

Posts: 3
Joined: 10/12/2007
Status: offline

I'm replACING THE FRONT END ON an 89 BLazer. HAD TO CHange out the steering bAR THat goes from wheel to wheel. WANTING TO KNOW WHat the torque specs ARE FOR THE BAll joints AT Each end? aND Maybe the toe in?

_____________________________

the sexiest goat alive

Post #: 1

RE: TORQUE specs on steering bAR Balljoints on AN 89 BL... - 10/12/2007 3:56:24 PM

swartlkk

Posts: 15294
Joined: 5/1/2005
From: Waterloo, NY
Status: online

You'll need an alignment after a tierod end change. That is what you are talking about right, the tie rod ends?

Anyway, the the torque on the castle nut should be 40ftlbs, then tighten to the next closest opening for installation of the cotter pin.

And what's with the spastic caps lock?... Very annoying.

_____________________________

Kyle-