torsion bar lift (Full Version)

Blazer >> Modifications >> Suspension Tech >> Lifting Tech

torsion bar lift


  

otnietdehoooo -> torsion bar lift (11/2/2007 12:26:46 PM)

Well, i finally cranked my tbars about an inch. i have been kind of on the edge about doing it but now thats its done i think it looks MUCH better.  i didnt really want to lift it, i mainly wanted to level it out. the drivers side was a little higher than the passengers side and i wanted to level it out front to rear a little more. i am going to take it in to get an alignment within the next two to three weeks however, the front wheels look a lot straighter than they did before


you may not be able to tell much of a difference but i certainly can, it is much more horizontal now instead of slightly raked like it used to be


if you click on it, it will take you to a higher resolution picture

[image]http://aycu02.webshots.com/image/32201/2000407825954065457_fs.jpg[/image]


  

coplinb -> RE: torsion bar lift (11/2/2007 12:31:19 PM)

looks good, nice and even.


YepIOwnA97Blazer -> RE: torsion bar lift (11/2/2007 1:04:09 PM)

looks very nice!


TripleBlackBlazer -> RE: torsion bar lift (11/2/2007 1:44:26 PM)

How many turns?  My crank was to gain the same objective-ever 'er out.  Took 5 turns to get it within 1/4" of the back (top of tire to bottom of fenderwell).

Looks great!


otnietdehoooo -> RE: torsion bar lift (11/2/2007 1:58:07 PM)

about 2.5 turns on drivers side and about 3 turns on pass side. i know i have read about 1 turn = 0.25" but there is nearly and inch in height difference after the lift


Johnkoch -> RE: torsion bar lift (11/2/2007 8:43:33 PM)

Looks good


  

Page: [1]

Return to Blazer Forum home page or view the Full Version of this page.