Blazer Forum Blazer Forum  
Chevy Blazer Forums
Chevrolet Blazer Forums
Chevrolet Blazer Blazer Forum   Classifieds   Photo Gallery   Search   Contact BF   Sponsors
  Blazer News   Member List   Forum FAQ   Timeslips   Recalls   TSBs   Calendars   Register   Login  

my blazer has STARTING problems

  Printable Version
Blazer Forum >> Mechanical & Maintenance >> General Tech Help >> 1st Gen S-series (1983-1994) Tech >> my blazer has STARTING problems Page: [1]
Login
Message << Older Topic   Newer Topic >>
my blazer has STARTING problems - 1/1/2006 6:09:17 PM   
Dean S

 

Posts: 5
Joined: 1/1/2006
Status: offline
my 87 blazer wont start until it turns over for 15 seconds? i changed the relays on the finder thanking it was a fuel pump relay but i noticed that it starts up after the oil pressure gauge moves to 15 psi or if i give it a shot of starting fluid. after it starts it runs fine???????????? any HELP OUT THERE 2.8 auto matic TBI
Post #: 1
RE: my blazer has STARTING problems - 1/1/2006 11:20:29 PM   
Hanr3


Wheels & Tire Moderator
Posts: 3523
Joined: 5/11/2005
Status: offline
Hanr3's photo gallery
It could be a faulty oil pressure sending unit.

My '87 2.8 S10-Blazer has two diferent oil pressure sending units. Most repair manuals show either a 1 wire, 2 wire, or 3 wire unit. I have a 2 wire & a 3 wire units. The oil pressure sending units are located next to eth oil filter. Take a look at your and post up what oyu have.

Take a look at Autozones web site. They have wireing diagrams for our trucks on line.

_____________________________

"Some people spend an entire lifetime wondering if they made a difference.
The Marines don't have that problem."
-President Ronald Reagan

'87 S10-Blazer - SOLD
'93 S10-Blazer 4x4x4 - Sons DD, engine swap is done.
'00 S10-Blazer 4x4x4 - My

(in reply to Dean S)
Post #: 2
RE: my blazer has STARTING problems - 1/2/2006 2:01:01 PM   
Canadian88


Posts: 489
Joined: 11/23/2005
From: Detroit
Status: offline
Canadian88's photo gallery
This is quite inlikely, but its a cheap fix, and its easy to check. If you live in a cold environment, and some moisture got into your distributor cap, it may have frozen, expanded, and cracked it. It is held down with two screws, and it costs less than ten bucks. Just take it into a dark room and put a flashlight under it to see if there is any light coming through where it shouldn't. Its a long shot, but its cheap.

_____________________________

2003 4.3L 2WD Blazer 2DR K&N air filter
Alpine S-type speakers in all 4 corners
Damplifier behind all speakers and in cargo area
Alpine CDA-9856 (iPod interface)
Alpine 10" type S Sub with 400W Alpine MRP-M450 amp www.secondskinaudio.com

(in reply to Hanr3)
Post #: 3
RE: my blazer has STARTING problems - 1/30/2006 12:51:35 AM   
matt_87_s10_blazer

 

Posts: 20
Joined: 12/10/2005
Status: offline
my 88 with the 2.8 did the same thing and i dident know what it was so i went and got the tbi unit off my old one (blown moter) and put it on now it starts right up

_____________________________

had 88 s-10 blazer 2dr 4wd
geting 87
wrecked poor 91 probe lx

(in reply to Canadian88)
Post #: 4
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Blazer >> Mechanical & Maintenance >> General Tech Help >> 1st Gen S-series (1983-1994) Tech
Jump to:



Featured Sponsors
Advertising Info

Top 10 Posters
swartlkk15276
drperry3925
hanr33523
chevy lover3411
m00nwater3269
eurogoldls3121
wolfpack3071
paddle_grl2951
hillbillyino2887
xblazer012659

New Vendors
AMSOIL - Performance Oil Technology

Add Blazer Forum to your favorites Contact Us | Advertising | Partners | About Us | Archive | Links | Link To Us | Legal | Privacy Policy | © Blazer Forum

Blazer Forum .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.