|
HeyYou -> RE: '92 S10 Blazer 4.3L TBI (1/10/2008 5:55:48 AM)
|
There should be a "Set timing" connector, that has to be disconnected when you set timing. I think it is on the passenger side, by the a/c box, should be a tan wire, with a black stripe, single wire, inline connector. (to the best of my knowledge, your results may vary....) Disconnect it, start the engine, set the timing. Shut off engine, reconnect, and see if it runs any better. (you will prolly have to clear codes after setting the timing.) Check fuel pressure. Although, this may be fun on a tbi, don't think it has the schrader valve..... Does it smoke? Use a lotta oil? Might be low compression. When is the last time it had a tune up?
|
|
|
|