changed CAS now no spark

	Blazer Forum Classifieds Photo Gallery Search Contact BF Sponsors
Blazer News Member List Forum FAQ Timeslips Recalls TSBs Calendars Register Login

changed CAS now no spark

Printable Version

Blazer Forums >> Mechanical & Maintenance >> Engine & Transmission >> changed CAS now no spark

Page: [1]

Message

<< Older Topic Newer Topic >>

changed CAS now no spark - 3/10/2008 9:20:57 PM

kennydawgg

Posts: 6
Joined: 3/10/2008
Status: offline

ok heres my problem maybee someone can help

I have a 97 blazer, and it was running rough. Then It sat for a couple weeks and when I went out to drive it it was real rough cranking and eventually broke the half moon part of the starter case off. so I did some research and concluded that it needed a new crank angle sensor, along with the new starter. So I replaced both and now the motor just cranks with no spark. Fuel is there but when I try to connect my scanner it says that it can not connect to the computer.

Anyone have any thoughts? I looked at all the fuses by the drivers door and they all look intact, is there anywhere else I can look for fuses?

I also tried putting my old CAS in and with no result so the new one went back in.

Thanks
Kenny

Post #: 1

RE: changed CAS now no spark - 3/10/2008 11:19:55 PM

thegr81

Posts: 2639
Joined: 1/16/2007
From: PHOENIX,AZ
Status: offline

What is the battery at as far as volts?? I have had happen where a dead cell battery will give you the same output! Just want to rule that out!!

_____________________________

2001 2wd 4.3 vortec v6
"I'm not fat, I'm a minitrucker"