New Seat time, help me out (Full Version)

Blazer >> Mechanical & Maintenance >> General Tech Help >> Full Size Tech

New Seat time, help me out

drewski120 -> New Seat time, help me out (4/22/2008 6:01:04 PM)
OK, in my 1974 K5 blazer it currently has bucket seats which are worn but ok and i wanna replace them with a single bench seat, because it has no back seat at all...so i want to put a bench seat in the front...what would i get this seat out of? K10 C10???? where do i find it lol...and will i have any trouble bolting it in, will i have to tap any new holes or what? Thanks again

BigBlack73 -> RE: New Seat time, help me out (4/23/2008 6:30:58 PM)
i highly doubt that's possible, the hump in the center to clear the tranny will make it impossible, or very difficult, to put a bench seat in it.

blazinrebel -> RE: New Seat time, help me out (4/24/2008 11:45:22 AM)
as for where to get the bench i might look in about the same year silverado, but to make it fit i would mount the old brackets to the bench. in my truck the seem to clear the tranny tunnel, then you could just run the cable from the driver side to the passanger side to make the seat slide.

drewski120 -> RE: New Seat time, help me out (4/28/2008 4:08:31 PM)
Thanks for the info guys! I think i can make it work.

2002XTREME -> RE: New Seat time, help me out (4/28/2008 4:49:43 PM)
how bout a suburban? they had bench seats, try on craigslist.org ...

Page: [1]

Return to Blazer Forum home page or view the Full Version of this page.