New Seat time, help me out
Login | |
|
New Seat time, help me out - 4/22/2008 6:01:04 PM
|
|
|
drewski120
Posts: 15
Joined: 3/31/2008 Status: offline
|
OK, in my 1974 K5 blazer it currently has bucket seats which are worn but ok and i wanna replace them with a single bench seat, because it has no back seat at all...so i want to put a bench seat in the front...what would i get this seat out of? K10 C10???? where do i find it lol...and will i have any trouble bolting it in, will i have to tap any new holes or what? Thanks again
_____________________________
Andrew
|
|
|
|
|
|
|
|
RE: New Seat time, help me out - 4/24/2008 11:45:22 AM
|
|
|
blazinrebel
Posts: 91
Joined: 3/26/2008 Status: offline
|
as for where to get the bench i might look in about the same year silverado, but to make it fit i would mount the old brackets to the bench. in my truck the seem to clear the tranny tunnel, then you could just run the cable from the driver side to the passanger side to make the seat slide.
_____________________________
'93 Chevy Blazer (Full-Size) two-door 350 small block 4x4 JL Audio Sub and Amp Custom Camo Interior
|
|
|
|
Blazer Forum .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.
|