Blazer Forum Blazer Forum  
Chevy Blazer Forums
Chevrolet Blazer Forums
Chevrolet Blazer Blazer Forum   Classifieds   Photo Gallery   Search   Contact BF   Sponsors
  Blazer News   Member List   Forum FAQ   Timeslips   Recalls   TSBs   Calendars   Register   Login  

Grrr. rattle is back

  Printable Version
Blazer Forums >> Mechanical & Maintenance >> General Tech Help >> 2nd Gen (1995-2005) Tech >> Grrr. rattle is back Page: [1]
Login
Message << Older Topic   Newer Topic >>
Grrr. rattle is back - 6/28/2008 9:29:27 PM   
portcqb


Posts: 293
Joined: 3/13/2008
Status: offline
So I thought I fixed the rattle when I put a wedge in to hold the computer from rattling. The rattle went away apperently only by luck since the rattles back and thats still snug. I have checked hood bolts, bumper pieces, done the wiggle test for the ball joints, pulled on the tie rods and changed the shocks. Pitman and idler arms were changed like 2k ago so if they are the problem I will flip. Lower balljoints were also changed at that point uppers are originals. Nothing wiggled when I had it lifted up and everything is good and greased. What can it be its driving me nuts. It rattles only when going over bumps and holes. It is coming from the right front. If I grab the roof rack or door area and shake the truck back and forth from that corner I can hear the same rattle noise. Anyone have any other things I should check? If everyone is out of ideas I may record the sound.

_____________________________

'97 Olds Bravada AWD 4.3L ~34,000mi(high idle time)
Post #: 1
RE: Grrr. rattle is back - 6/30/2008 5:01:30 PM   
portcqb


Posts: 293
Joined: 3/13/2008
Status: offline
Anyone, im running out of things to check. It should probably be called a clunk not a rattle.

_____________________________

'97 Olds Bravada AWD 4.3L ~34,000mi(high idle time)

(in reply to portcqb)
Post #: 2
RE: Grrr. rattle is back - 7/4/2008 8:38:24 AM   
portcqb


Posts: 293
Joined: 3/13/2008
Status: offline
If it helps a little more detail, It is worse after driving then when you first leave for the day. Also it seems to be getting worse.

_____________________________

'97 Olds Bravada AWD 4.3L ~34,000mi(high idle time)

(in reply to portcqb)
Post #: 3
RE: Grrr. rattle is back - 7/4/2008 1:03:35 PM   
natenorrish

 

Posts: 8
Joined: 7/3/2008
Status: offline
Strange, I have a similar problem with my Mitsubishi Galant. I hear a rattle over large bumps and when pulling away (due to low rev vibrations). This started happening when one night dropping a friend off at his house, he lives where the roads are uneven (could have done with the blazer!!) and i grounded the car. I think my problem is something simple like a rubber support has fallen off the exhaust (well I hope anyway!) 

If it''s a clunk then it''s something that should be clipped in or supported, where as a rattle / vibration would be something that needs padding / support tightening. Seems like a tube of some kind but not necessarily rubber.. as it would have to be heavy. If there is a delay between going over the bump and the clunk, would indicate something swaying. But all the things you''ve replaced are what immediately came to my mind. So I''m stumped too!


(in reply to portcqb)
Post #: 4
RE: Grrr. rattle is back - 7/10/2008 9:07:25 PM   
portcqb


Posts: 293
Joined: 3/13/2008
Status: offline
The clunk I guess it should be called will happen instantly on a bump. It will also happen if I push fairly hard down on that corner of the truck. I have also since checked the torsion bar mounts and the control arm bushings.

_____________________________

'97 Olds Bravada AWD 4.3L ~34,000mi(high idle time)

(in reply to natenorrish)
Post #: 5
RE: Grrr. rattle is back - 7/21/2008 1:53:39 PM   
SL5417

 

Posts: 1
Joined: 7/21/2008
Status: offline
Had a similar noise on another suv and it ended up it was the ball joint.  Good luck rattles drive me crazy also.

(in reply to portcqb)
Post #: 6
RE: Grrr. rattle is back - 7/21/2008 6:40:41 PM   
packofqtips

 

Posts: 103
Joined: 3/8/2008
Status: offline
packofqtips's photo gallery
did you check the sway bar endlinks?

(in reply to SL5417)
Post #: 7
RE: Grrr. rattle is back - 7/21/2008 8:35:13 PM   
portcqb


Posts: 293
Joined: 3/13/2008
Status: offline
Sorry left that out, they are new also. One thing to add I dont know if its from back when I had a bad balljoint or if its still getting worse but the inside most tread and the middle tread on that tire are worn more than the others.

_____________________________

'97 Olds Bravada AWD 4.3L ~34,000mi(high idle time)

(in reply to packofqtips)
Post #: 8
Login OR Register now to post a reply to this forum topic.
Page:   [1]

 
Blazer Forums >> Mechanical & Maintenance >> General Tech Help >> 2nd Gen (1995-2005) Tech
Jump to:



Featured Sponsors
Advertising Info

Top 10 Posters
swartlkk12842
drperry3850
chevy lover3409
hanr33376
m00nwater3269
eurogoldls3063
paddle_grl2929
hillbillyino2880
xblazer012659
thegr812621

New Vendors
AMSOIL - Performance Oil Technology
K&N Engineering, Inc.

Add Blazer Forum to your favorites Contact Us | Advertising | Partners | About Us | Archive | Links | Link To Us | Legal | Privacy Policy | © Blazer Forum

Blazer Forum .com is not affiliated with or endorsed by Chevrolet Motors Division or General Motors.