Ohm's Law (Full Version)

Blazer >> Modifications >> Audio/Visual Electronics

Ohm's Law

  

jagblazer01 -> Ohm's Law (9/24/2006 1:20:08 AM)

I found this and figured id post it here in case anyone was interested

Ohm's Law defines the relationships between (P) power, (E) voltage, (I) current, and (R) resistance. One ohm is the resistance value through which one volt will maintain a current of one ampere.

( I ) Current is what flows on a wire or conductor like water flowing down a river. Current flows from points of high voltage to points of low voltage on the surface of a conductor. Current is measured in (A) amperes or amps.

( E ) Voltage is the difference in electrical potential between two points in a circuit. It's the push or pressure behind current flow through a circuit, and is measured in (V) volts.

( R ) Resistance determines how much current will flow through a component. Resistors are used to control voltage and current levels. A very high resistance allows a small amount of current to flow. A very low resistance allows a large amount of current to flow. Resistance is measured in ohms.

( P ) Power is the amount of current times the voltage level at a given point measured in wattage or watts

Thank you the12volt.com

here's the link, its got all kinds of stuff on there including a calculator
http://www.the12volt.com/ohm/ohmslaw.asp

  
XBlazer01 -> RE: Ohm's Law (9/24/2006 1:40:34 AM)

VERY USEFUL

Nice post jimmy u get a sticky

jagblazer01 -> RE: Ohm's Law (9/24/2006 1:43:09 AM)

yay i feel special lol[sm=happy046.gif]

Scubasteve2365 -> RE: Ohm's Law (10/23/2006 10:51:16 PM)

The name of this thread is "Ohm's Law" but you forgot to actually state the law

V = IR

I = V/R

R = V/I

Voltage through a load multiplied by the current through a load will yeild Power [in Watts].

P = I*V

I'm an electrical engineer by degree and profession, and an audio/video guru by experience. I worked in 12Volt electronics for along time, and this sometimes proved usefull, but continuity meters proved more usefull in the land of 12V.

splblazer -> RE: Ohm''s Law (7/7/2008 10:29:41 PM)

Voltage through a load multiplied by the current through a load will yeild Power [in Watts].

thats correct. but if u dont mutyply the number by 0.707 it wont give u the true RMS. it will give u the max power
please repost if im wrong. thx


MrBill -> RE: Ohm''''s Law (12/4/2008 8:10:07 AM)

quote:

ORIGINAL: splblazer

Voltage through a load multiplied by the current through a load will yeild Power [in Watts].

thats correct. but if u dont mutyply the number by 0.707 it wont give u the true RMS. it will give u the max power
please repost if im wrong. thx




You''re talking AC, not DC.  12V vehicle electrical systems are primarily DC.  The .707 factor is the root-mean-square "average" of a symmetrical AC sine wave.

(old post I know...but I just signed up recently, was browsing around and stumbled across this).

Also being a EE...I wrote up a little article on electronics that someone may find handy (or may not, but hey is there a such thing as too much information!  [:D] )

http://misterbill.homeip.net/misc/basic%20electronics.PDF

  

Page: [1]

Return to Blazer Forum home page or view the Full Version of this page.