idleing down, stops running.
Login | |
|
idleing down, stops running. - 4/8/2007 8:13:12 PM
|
|
|
thevair65
Posts: 84
Joined: 1/24/2007 Status: offline
|
this is the final straw in a set of odd problems. When i start my truck it runs for about 10 seconds then dies. if i hold my foot on the gas just a little for about 30 seconds it will stay running but the idle is rough and inconsistant. My check engine is on so i plan on putting an OBD1 decoder on it but just wanted to see if anyone had any ideas. Thanks. 89 K5. 350 stock. 4x4
|
|
|
|
|
|
RE: idleing down, stops running. - 4/8/2007 8:23:55 PM
|
|
|
swartlkk
Posts: 14499
Joined: 5/1/2005 From: Waterloo, NY Status: offline
|
Just to throw this out there, when was the last time you did a full tune up? Plugs, wires, cap & rotor? If recent, then it sounds like there may be a problem with the EGR system or a vacuum leak...
_____________________________
Kyle- 04 Rainier My Restoration Projects Please Do Not PM for Tech Help
|
|
|
|
RE: idleing down, stops running. - 4/8/2007 8:27:46 PM
|
|
|
thevair65
Posts: 84
Joined: 1/24/2007 Status: offline
|
tune up was pretty recent. this all started when instead of idleing down it would idle very high and was so high i didnt dare put it into gear so it hasnt seen much road time recently. ive thought of a vacuum leak as well but i dont know where it would have come from. i parked it a few months ago and havent touched since and it ran fine then so i dont understand. thanks.
|
|
|
|
RE: idleing down, stops running. - 4/8/2007 8:30:58 PM
|
|
|
swartlkk
Posts: 14499
Joined: 5/1/2005 From: Waterloo, NY Status: offline
|
A lot of vacuum leaks originate at the throttle body gasket. I'd take an unlit propane torch and direct it around the base of the throttle body and around any other areas that may be suspect for leaks. If the RPMs rise, then you've found your leak.
_____________________________
Kyle- 04 Rainier My Restoration Projects Please Do Not PM for Tech Help
|
|
|
|
RE: idleing down, stops running. - 4/8/2007 8:38:58 PM
|
|
|
thevair65
Posts: 84
Joined: 1/24/2007 Status: offline
|
ok cool ill give it a try Thanks. only one question though. i dont know if the trruck has a sensor for the vacuum pressure and the check engine light is on and wasnt until now.
< Message edited by thevair65 -- 4/8/2007 8:47:39 PM >
|
|
|
|
RE: idleing down, stops running. - 4/10/2007 3:44:37 PM
|
|
|
thevair65
Posts: 84
Joined: 1/24/2007 Status: offline
|
well this whole things went from bad to worse. i got an OBD1 decoder and a propane torch and was headed out to try a few suggestions out. now the truck doesnt even start so im very stuck. im not quite sure where to start, this came up out of no where. any suggestions? besides the fuel pump ive already thought of that one hehe Thanks
|
|
|
|
|